Nexarius

This is my stargate control program for sgcraft called nexDHD
 

 
How to get it:
link to github

pastebin run -f YVqKFnsP

 
Computer requirements:
- CPU T2
- GPU T2
- 12x Screen T2
- HDD T1 (with OpenOS)
- 2x Memory T1.5
- Internet Card - only required for installation and updates
- keyboard - only required for installation
- Redstone Card T2 - optional
- EEPROM (Lua BIOS)
 
features of my program:
- autoclose iris on incoming wormhole (when iriscontrol is turned on)
- autoopen iris if correct IDC is received (iris deactivation code)
- autoclose stargate after X seconds
- show all kinds of stats (local / remote address, state, direction, idc, iris state, energy, ...)
- multiple languages: right now german, english and russian
- displays energy in EU or RF
- displays up to 10 addresses on 1 page (unlimited pages)
- allows dialing from the address list
- check for updates on start
- emit redstone signals (right now for: state not idle, incoming, iris closed, idc accepted, wormhole connected)
- automatically adds new, unkown addresses when there is an open wormhole
- shows the required energy to dial an address (or error if invalid address)
- allows closing of incoming wormholes if its disabled in config AND there is a computer at either end
- automatically sends and receives entire address list on an open wormhole (without the IDC of course) and automatically adds the new addresses
- with touchscreen functionalities
- works with Computronics ColorfulLamps -> red = iris closed, green = idc accepted, yellow = outgoing wormhole, orange = incoming wormhole (priority from left to right)
- logbook with the last connections

1)

I don't think you should make a thread with two different subjects.

2)

You might want to check out my stargate programm. It allows dialling (from an address list) and automated iris control

The automated iris control (which can be turned off if you want) can automatically close the iris on an incoming wormhole and open it automatically if the correct IDC is received but the programm is not wireless or with tablets. It works over the stargate computer interfaces and obviously you need this computer control programm on both sides for it to work with the IDC because one computer is sending the IDC and the other one is receiving it.

It can also output some stargate states as redstone signals, work with computronics colorfullamps and you can choose between different languages (right now only german and english).

https://github.com/Nex4rius/Stargate-Programm

I'm sometimes getting this error but if I just restart the computer it works fine for a while before I get this error again.

But when I run this to check all connected components.

I'm only getting 20 components.

And my computer should be able to have 36 attached components.

What am I doing wrong?

https://github.com/MightyPirates/OpenComputers/issues/1908

I'm sometimes getting an error that there are too many components connected to my computer but when I restart it (without removing or adding anything) it works fine again for about a week.

Then I check how many components I have connected to the computer so I run this

to get this

Then I check my computer.

I has a CPU Tier 2 and 2x Component Bus Tier 2 which should give me a maximum number of 36 components and I'm only using 20.

Why do I get the too many components connected error?