Problems turning computer on

[Maccaroney 0]

Hey guys, i've built a basic setup in creative mode to begin my journey in OpenComputers but i can't turn the computer on. When i click the on button it just IMMEDIATELY turns back off. I can't figure out why.

Any help would be appreciated.
Thanks.

[Daraketh 2]

Details? Got something to power it? I think there are some options in the config to use no power if that's your thing, don't quote me on that though.

 

My typical test set-up is the APU, RAM, HDD, openOS floppy, lua EEPROM, internet card, which all goes in the T3 Case (don't forget to use "install' once it boots).

 

Then you need a screen with a keyboard attached.

 

Finally (if you haven't turned power requirement off in config) you need a power converter block attached to some sort of power source (various creative batteries from other mods).

 

Again, don't quote me on this, but I think creative cases don't require power, so that might be an option too.

 

If you do all of that you should be able to boot it up without a problem.

[meigrafd 0]

The 'Creative' Computer-Case (tier 4) doesnt need Power.

[dgelessus 26]

When hovering over the power button in the GUI it should show you the reason why it crashed the last time (IIRC). Alternatively you can right-click the case with an analyzer to see a few details, including the last error.