MrSmirkNMerc

I just ran the energy down to under 10% capacity and the turbines kicked in. However they only stayed on for a few minutes until the cell was filled to about 20% percent and then shut off. Is there a way to set the threshold of when the program shuts the turbines off again to a higher percentage?

OK I wanted to make sure. I drained my cell to under 50% and thought that it should've kicked in by then. I put the Holding IV enchant on the cell and it holds 150 mil. I was thinking about going into Draconic next. I also have Capacitor Bank of 50 mil, but I was reading that you need a mod that I don't have installed for the adapter to interact with the capacitor bank. Thanks for the info.

I hope this isn't a dumb question. I am new to open computers and this reactor program. I saw it on Direwolf20's let's play and mimicked his setup for Extreme Reactors. I followed everything he did except for with my base I have a resonant energy cell that I've attached the adapter to. I've run the program and everything works fine until I reach a point after calibration where it says the turbine is suspended. That never happened in the DW20's video and I'm not well versed enough to diagnose the problem. Any assistance would be greatly appreciated. The reactor is 9x9. The turbine is