nmarshall23 0 Posted February 9, 2015 Share Posted February 9, 2015 I can't figure out how to read how full my Railcaft tanks are. I tried using the adapter, but I didn't see an new component. Quote Link to post Share on other sites
0 Sangar 92 Posted February 10, 2015 Share Posted February 10, 2015 You'll need to place a tank controller into the adapter and use that to get information about the fluid in the tank. I'm not sure without testing if the adapter would have to be next to a valve / the bottom center block or if any part of the tank will work, so you might want to try placing it at different parts of the tank, too. Quote Link to post Share on other sites
0 nmarshall23 0 Posted February 11, 2015 Author Share Posted February 11, 2015 Thanks, I figured it out. The adapter with the tank controller has to be next to a valve. I found a bug, my adapter next to my tank was also next to the ender IO conduit. I could not see the tank controller, only the ender IO conduit. Soon as I removed the conduit I could see the tank controller. Quote Link to post Share on other sites
I can't figure out how to read how full my Railcaft tanks are. I tried using the adapter, but I didn't see an new component.
Link to post
Share on other sites